Home › Engine / Hybrid System · 1AZ-FE › STARTING › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STARTER RELAY


    B060778E26
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage applied between terminals 1 and 2
    Below 1 Ω

    If the resistance is not as specified, replace the starter relay.