Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System) > Diagnosis Circuit

for Preparation Click here


DESCRIPTION

This circuit is used to read the DTCs that are output from the transponder key ECU assembly with the intelligent tester.

WIRING DIAGRAM


B193465E07


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - TRANSPONDER KEY ECU AND BODY GROUND)
  1. Disconnect the DLC3 connector.

  1. Disconnect the transponder key ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I19-9 (D) - I39-7 (SIL)
    Always
    Below 1 Ω
    I39-4 (CG) - Body ground
    Always
    Below 1 Ω
    I19-9 (D) - Body ground
    Always
    10 kΩ or higher
    I39-7 (SIL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)