Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System)

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is ON even when the key is in the ignition key cylinder. Under normal conditions, the unlock warning switch assembly is ON when the key is in the ignition key cylinder.

DTC No.
DTC Detection Condition
Trouble Area
B2780
"Unlock warning switch ON" is not detected when the key is in the ignition key cylinder.
  1. Wire harness or connector
  2. Unlock warning switch assembly
  3. Transponder key ECU assembly

WIRING DIAGRAM


B278950E01


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, refer to Service Bulletin.

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Immobiliser / Data List.

  1. Read the Data List according to the display on the intelligent tester.

    Immobiliser (Transponder Key ECU Assembly) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key SW
    Unlock warning switch signal/ON or OFF
    ON: Key in ignition key cylinder
    OFF: No key in ignition key cylinder
    -

    OK:
    On the intelligent tester screen, the item changes between ON and OFF according to the chart above.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY 

2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B203483E04
  1. Remove the unlock warning switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    (Key set)
    Below 1 Ω
    1 - 2
    Free
    (Key removed)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Unlock Warning Switch Assembly)
    *b
    Free
    *c
    Pushed



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU AND BODY GROUND)
  1. Disconnect the transponder key ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I19-3 (KSW) - I33-1 (UN+)
    Always
    Below 1 Ω
    I19-3 (KSW) - Body ground
    Always
    10 kΩ or higher
    I33-2 (UN-) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY