Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 COOLER THERMISTOR


    E168014E05
  1. Install the No. 1 cooler thermistor as shown in the illustration.
    Text in Illustration 
    *a
    Fixed Part
    *b
    Sensor Part
    Part
    Length
    A
    34.3 mm
    1.35 in.
    B
    20.9 mm
    0.822 in.
    C
    50 mm
    1.96 in.

    NOTICE:
    1. Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
    2. When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
    3. After inserting the thermistor, do not apply excessive force to the wire.
    4. Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".



2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    E167988
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the No. 1 cooler evaporator sub-assembly to the blower assembly.

    NOTICE:
    Keep the O-rings and O-ring fitting surfaces free from dirt or any foreign objects.



    E179587
  1. Engage the clamp to install the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor.

    HINT:
    Completely cover the tube with the grommet.



    E179586
  1. Engage the 5 claws.

  1. Install the plate cover with the 6 screws.



3. INSTALL AIR CONDITIONING RADIATOR ASSEMBLY


    E228069
  1. Engage the 2 claws.

  1. Install the air conditioning radiator assembly with the 2 screws.



4. INSTALL COOLER EXPANSION VALVE


    E228074
  1. Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }



5. CONNECT AIR CONDITIONING HARNESS ASSEMBLY
  1. Engage the 3 guides and connect the 3 connectors.

  1. Connect the air conditioner harness assembly to the air conditioning unit assembly.



    E228073
  1. Install the heater packing as shown in the illustration.



6. INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY


    E227194
  1. Engage the 2 claws and 2 guides to install the No. 6 heater to register duct assembly as shown in the illustration.



7. INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY


    E227192
  1. Engage the guide and 2 claws to install the No. 1 air duct sub-assembly as shown in the illustration.



8. INSTALL AIR CONDITIONING UNIT ASSEMBLY
(Click here)