Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE AIR CONDITIONING UNIT ASSEMBLY
(Click here)


2. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY


    E227191
  1. Disengage the 2 claws and guide, and remove the No. 1 air duct sub-assembly as shown in the illustration.



3. REMOVE NO. 6 HEATER TO REGISTER DUCT ASSEMBLY


    E227193
  1. Disengage the 2 claws and 2 guides, and remove the No. 6 heater to register duct assembly as shown in the illustration.



4. DISCONNECT AIR CONDITIONING HARNESS ASSEMBLY


    E228072
  1. Remove the heater packing as shown in the illustration.



    E228086
  1. Disconnect the 3 connectors and disengage the 3 guides.

  1. Disconnect the air conditioner harness assembly from the air conditioning unit.



5. REMOVE AIR CONDITIONING RADIATOR ASSEMBLY


    E228069
  1. Remove the 2 screws.

  1. Disengage the 2 claws and remove the air conditioning radiator assembly.



6. REMOVE COOLER EXPANSION VALVE


    E228074
  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.



7. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    E179586
  1. Remove the 6 screws.

  1. Disengage the 5 claws and remove the plate cover.



    E179587
  1. Disengage the clamp and remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor.



    E167988
  1. Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.



8. REMOVE NO. 1 COOLER THERMISTOR


    E228572
  1. Remove the No. 1 cooler thermistor.