WATER PUMP > REMOVAL |
| 1. REMOVE V-RIBBED BELT |
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Loosen the cylinder block drain cock plug (for Bank 1).
Loosen the cylinder block drain cock plug (for Bank 2, w/ Cylinder Block Drain Cock Plug).
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Cylinder Block Drain Cock Plug (for Bank 1) |
| *3 | Cylinder Block Drain Cock Plug (for Bank 2, w/ Cylinder Block Drain Cock Plug) | *4 | Radiator Drain Cock Plug |
| *5 | Air Drain Cock Plug | - | - |
| 3. DISCONNECT NO. 2 RADIATOR HOSE |
![]() |
Disconnect the No. 2 radiator hose.
| 4. REMOVE NO. 2 ENGINE MOUNTING STAY RH (for Engine Mounting stay Side) |
![]() |
Remove the bolt, 2 nuts and No. 2 engine mounting stay RH.
| 5. REMOVE NO. 2 ENGINE MOUNTING STAY RH (for Intake Manifold Side) |
![]() |
Remove the bolt and No. 2 engine mounting stay RH.
| 6. REMOVE ENGINE MOVING CONTROL ROD BRACKET |
![]() |
Remove the 4 bolts and engine moving control rod bracket with engine moving control rod.
| 7. REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH |
![]() |
Using SST, remove the bolt.
![]() |
Remove the 5 bolts and front No. 1 engine mounting bracket LH.
| 8. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY |
![]() |
Remove the bolt, No. 2 idler pulley cover plate, No. 2 idler pulley sub-assembly and idler pulley cover plate.
| 9. REMOVE V-RIBBED BELT TENSIONER PULLEY |
Remove the 5 mm bi-hexagon wrench.
![]() |
Remove the bolt and V-ribbed belt tensioner pulley and dust shield.
| 10. REMOVE WATER INLET HOUSING |
![]() |
Disconnect the water hose.
| *1 | Water hose |
| *2 | Water Inlet housing |
Remove the 2 bolts, nut and water inlet housing.
![]() |
Remove the 2 O-rings.
| 11. SEPARATE WATER PUMP PULLEY |
![]() |
Using SST, hold the water pump pulley.
Using SST and union nut wrench, remove the 4 bolts and separate the water pump pulley from the engine water pump.
| 12. REMOVE ENGINE WATER PUMP ASSEMBLY |
![]() |
Remove the 16 bolts, engine water pump assembly, water pump pulley and gasket.