Home › Engine / Hybrid System ยท 2GR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.

  1. Loosen the cylinder block drain cock plug (for Bank 1).

  1. Loosen the cylinder block drain cock plug (for Bank 2, w/ Cylinder Block Drain Cock Plug).



  1. Remove the radiator cap sub-assembly.


    A255284E02


    Text in Illustration 
    *1
    Radiator Cap Sub-assembly
    *2
    Cylinder Block Drain Cock Plug (for Bank 1)
    *3
    Cylinder Block Drain Cock Plug (for Bank 2, w/ Cylinder Block Drain Cock Plug)
    *4
    Radiator Drain Cock Plug
    *5
    Air Drain Cock Plug
    -
    -

    HINT:
    Collect the engine coolant in a container and dispose of it according to the regulations in your area.



2. REMOVE V-RIBBED BELT
(Click here)


3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    A206493
  1. Remove the bolt, No. 2 idler pulley cover plate, No. 2 idler pulley sub-assembly and idler pulley cover plate.



4. DISCONNECT NO. 2 RADIATOR HOSE


    A255430
  1. Disconnect the No. 2 radiator hose.



5. REMOVE WATER INLET


    A162796
  1. Remove the 2 nuts and water inlet.



6. REMOVE THERMOSTAT
  1. Remove the thermostat from the water inlet housing.

  1. Remove the gasket from the thermostat.