FUEL TANK > REMOVAL |
| 1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
| 2. DRAIN FUEL |
| 3. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
| 4. REMOVE NO. 1 FLOOR UNDER COVER |
![]() |
Disengage the 5 nuts and 2 clips, and remove the No. 1 floor under cover.
![]() | Nut (attached to under cover) |
| 5. REMOVE NO. 2 FLOOR UNDER COVER |
![]() |
Remove the 2 clips.
![]() | Nut (attached to under cover) |
Disengage the 6 nuts and remove the No. 2 floor under cover.
| 6. DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Remove the bolt and nut of the No. 2 parking brake cable assembly.
| 7. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Remove the bolt and nut of the No. 3 parking brake cable assembly.
| 8. REMOVE REAR NO. 1 STABILIZER BAR BRACKET |
![]() |
Remove the 4 bolts and 2 rear No. 1 stabilizer bar brackets.
| 9. REMOVE LOWER CENTER FUEL TANK PROTECTOR |
![]() |
Remove the 4 bolts and lower center fuel tank protector.
| 10. DISCONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Pinch the fuel tube connector and then pull out the fuel pump tube sub-assembly.
| *1 | Retainer |
| *2 | Fuel Pipe |
| *3 | Fuel Tube Connector |
| *4 | O-ring |
![]() | Pinch |
![]() | Pull Out |
| 11. REMOVE FUEL TANK ASSEMBLY |
![]() |
Loosen the clip, then disconnect the fuel emission hose from the charcoal canister.
![]() |
Support the fuel tank using an engine lifter.
![]() |
Remove the 2 bolts of the fuel tank bands.
Slightly lower the engine lifter.
![]() |
Loosen the hose clamp bolt and disconnect the fuel tank to filler pipe hose.
![]() |
Loosen the hose clamp bolt and disconnect the breather tube fuel hose.
Lower the engine lifter to remove the fuel tank.
![]() |
Remove the 2 pins and 2 fuel tank bands as shown in the illustration.
![]() |
Remove the 4 clip nuts.
| 12. REMOVE NO. 1 FUEL TANK CUSHION |
![]() |
Remove the No. 1 fuel tank cushion.
| *1 | No. 1 Fuel Tank Cushion |
| *2 | No. 2 Fuel Tank Cushion |
| 13. REMOVE NO. 2 FUEL TANK CUSHION |
Remove the 7 No. 2 fuel tank cushions.
| 14. REMOVE NO. 2 FUEL TANK PROTECTOR |
![]() |
Disengage the 2 claws, and remove the No. 2 fuel tank protector by sliding it as shown in the illustration.
| 15. REMOVE NO. 3 FUEL TANK PROTECTOR |
![]() |
Disengage the 2 claws, and remove the No. 3 fuel tank protector by sliding it as shown in the illustration.
| 16. REMOVE FUEL CUT OFF WITH TUBE VALVE ASSEMBLY |
![]() |
Insert a clip remover between the fuel cut off valve and the gasket and remove the fuel cut off valve by gradually pushing it upward.
| *1 | Fuel Cut Off Valve |
| *2 | Gasket |
Separate the 2 No. 4 fuel tube clamps.
Remove the 2 fuel tank breather tube gaskets.
| 17. REMOVE FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Disconnect the fuel main tube support, fuel tube clamp and remove the fuel pump tube sub-assembly.
| 18. REMOVE FUEL MAIN TUBE SUPPORT |
![]() |
Remove the bolt and fuel main tube support.
| 19. REMOVE NO. 4 FUEL TUBE CLAMP |
![]() |
Remove the 3 No. 4 fuel tube clamps.