Home › Vehicle Exterior › LIGHTING (EXT) › AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)

AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) > LVL Terminal Circuit

for Preparation Click here


DESCRIPTION

  1. By connecting terminals LVL and CG of the DLC3, the AFS ECU (headlight swivel ECU assembly) initializes the height control sensor signal.

WIRING DIAGRAM


E136349E20


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY))
  1. Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A35-7 (SPDL) - I39-8 (LVL)
    Always
    Below 1 Ω
    A35-7 (SPDL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I39-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)