Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for 1AZ-FE)

FRONT DRIVE SHAFT ASSEMBLY (for 1AZ-FE) > INSPECTION

for Preparation Click here



1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    C091598
  1. Check that there is no excessive play in the radial direction of the outboard joint.

  1. Check that the inboard joint slides smoothly in the thrust direction.

  1. Check that there is no excessive play in the radial direction of the inboard joint.

  1. Check the boots for damage.



    C240884E01
  1. Check whether the drive shaft dimensions (A) are within the following specifications.
    Text in Illustration 
    *A
    LH Side
    *B
    RH Side

    NOTICE:
    Keep the drive shaft assembly level during inspection.

    Dimension (A):

    Dimension (A)
    LH Side
    600.4 mm (1.97 ft.)
    RH Side
    898.6 mm (2.95 ft.)