Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    C083014
  1. Remove the bolt and separate the rear flexible hose from the rear shock absorber assembly.

  1. Remove the 2 bolts, and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the rear disc brake caliper assembly from hanging down by the rear flexible hose.



3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
  1. Remove the parking brake shoe adjusting hole plug.



4. REMOVE REAR DISC


    C238505E01
  1. Put matchmarks on the rear disc and the rear axle hub.
    Text in Illustration 
    *a
    Matchmark



    C201774
  1. Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.



5. DISCONNECT SKID CONTROL SENSOR WIRE


    C243054
  1. Using a screwdriver, disconnect the connector from the rear speed sensor.

    NOTICE:
    Be careful not to damage the rear speed sensor.



6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    C240559
  1. Remove the 4 bolts and the rear axle hub and bearing assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.