Home › Power Source / Network ยท 1AZ-FE BATTERY / CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > Charge Warning Light Comes ON while Driving

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK LOCK FUNCTION OF GENERATOR PULLEY WITH CLUTCH
  1. Check the lock function with the generator pulley with clutch installed in the vehicle.

    1. Visually check that the generator rotor assembly in the generator assembly operates with the engine started.



  1. Check the lock function with the generator pulley with clutch removed from the vehicle.

    1. Remove the generator pulley cap.



    2. A208964E03
    3. Hold the generator rotor assembly using SST, and turn the generator pulley with clutch clockwise to check that the outer ring locks .
      Text in Illustration 
      *a
      Free
      *b
      Lock

      OK:
      The outer ring locks.

SST
09820-63021  


NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK


2.CHECK LOCK OF GENERATOR PULLEY WITH CLUTCH
  1. Start the engine and visually check for looseness of the generator pulley with clutch.

    OK:
    The generator pulley with clutch is not loose.



NG
TIGHTEN GENERATOR PULLEY WITH CLUTCH TO THE SPECIFIED TORQUE
OK

REPLACE GENERATOR ASSEMBLY (Click here)