Home › Power Source / Network ยท 1AZ-FE BATTERY / CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > Noise Occurs from Generator while Engine is Running

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK LOOSENESS OF V-RIBBED BELT
  1. Check the tension of the V-ribbed belt by pushing it down with a finger.

    OK:
    The tension of the V-ribbed belt is enough.



NG
REPLACE V-RIBBED BELT TENSIONER ASSEMBLY (Click here)
OK


2.CHECK V-RIBBED BELT FOR WEAR
  1. Check the V-ribbed belt for wear.

    OK:
    The V-ribbed belt is not worn.



NG
REPLACE V-RIBBED BELT (Click here)
OK


3.CHECK GENERATOR PULLEY WITH CLUTCH FOR WEAR
  1. Check the generator pulley with clutch groove for wear or other defects.

    OK:
    The generator pulley with clutch groove is not damaged.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK


4.CHECK FOR NOISE WHILE GENERATOR PULLEY WITH CLUTCH IS OPERATING
  1. Perform a road test and check if noise occurs when decelerating.

    OK:
    Noise does not occur.



NG
REPLACE GENERATOR PULLEY WITH CLUTCH (Click here)
OK

REPLACE GENERATOR ASSEMBLY (Click here)