STEERING COLUMN ASSEMBLY > INSPECTION |
| 1. INSPECT PRELOAD (for Manual Tilt and Manual Telescopic Steering Column) |
![]() |
Secure the steering column assembly in a vice using aluminum plates as shown in the illustration.
| *1 | Aluminum Plate |
| *2 | Wooden Block |
![]() |
Install the 2 service nuts to the steering main shaft.
| *1 | Service Nut |
Simultaneously rotate the service nut that was installed first counterclockwise and rotate the service nut that was installed second clockwise to lock them.
![]() |
Using a torque wrench, turn the main shaft and measure the preload.
| 2. INSPECT PRELOAD (for Power Tilt and Power Telescopic Steering Column) |
![]() |
Securely set the steering column assembly on a wooden block or similar item.
| *1 | Wooden Block |
![]() |
Install the 2 service nuts to the steering main shaft.
| *1 | Service Nut |
Simultaneously rotate the service nut that was installed first counterclockwise and rotate the service nut that was installed second clockwise to lock them.
![]() |
Using a torque wrench, turn the main shaft and measure the preload.
| 3. INSPECT STEERING LOCK OPERATION (w/o Smart Entry and Start System) |
![]() |
Check that the steering lock mechanism is activated when the key is removed.
![]() |
Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.
| *a | LOCK |
| *b | ACC |
| 4. INSPECT STEERING COLUMN ASSEMBLY |
![]() |
Check that the 2 capsules are securely installed to the steering column assembly as shown in the illustration.
| A | B |
| 1 mm (0.0394 in.) | 12 mm (0.473 in.) |
| *1 | Capsule |
Check the 2 capsules for deformation and damage.
If either of the capsules is deformed, loose, missing or damaged, replace the electric power steering column sub-assembly with a new one.
| 5. INSPECT TILT MOTOR |
![]() |
Apply 12 V battery voltage to the tilt motor connector.
Then check the steering wheel tilt operation.
| Measurement Condition | Specified Condition |
| The steering wheel tilts down. |
| The steering wheel tilts up. |
| *a | Component without harness connected (Tilt Motor) |
| 6. INSPECT TELESCOPIC MOTOR |
![]() |
Apply 12 V battery voltage to the telescopic motor connector.
Then check the steering column telescopic operation.
| Measurement Condition | Specified Condition |
| The steering column contracts. |
| The steering column extends. |
| *a | Component without harness connected (Telescopic Motor) |