Home › Power Source / Network · 2GR-FE BATTERY / CHARGING › GENERATOR

GENERATOR > INSPECTION

for Preparation Click here



1. INSPECT GENERATOR CLUTCH PULLEY


    A240512E03
  1. Hold the generator rotor using SST, and turn the generator pulley with clutch clockwise to check that the outer ring locks.

    SST
    09820-63021  
    Text in Illustration 
    *a
    Free
    *b
    Lock
    If the result is not as specified, replace the generator pulley with clutch.



2. INSPECT GENERATOR DRIVE END FRAME BEARING


    A128080
  1. Check that the bearing is not rough or worn.

    OK:
    The bearing rotates smoothly.

    If the bearing does not rotate smoothly, replace the bearing.



3. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    A128079E11
  1. Using a vernier caliper, measure the length of the exposed brushes.
    Text in Illustration 
    *a
    Length

    Standard exposed brush length:
    9.5 to 11.5 mm (0.375 to 0.452 in.)

    Minimum exposed brush length:
    4.5 mm (0.178 in.)

    If the exposed brush length is less than the minimum, replace the brush holder assembly.



4. INSPECT GENERATOR ROTOR ASSEMBLY


    A079306E02
  1. Check that the generator rotor bearing is not rough or worn.
    If necessary, replace the generator rotor assembly.



    B012264E20
  1. Check the generator rotor for an open circuit.
    Text in Illustration 
    *1
    Slip Ring
    *2
    Ohmmeter

    1. Using an ohmmeter, measure the resistance between the slip rings.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      Approx. 20°C (68°F)
      2.3 to 2.7 Ω

      If the result is not as specified, replace the generator rotor assembly.



    B012265E15
  1. Check the rotor for a short to ground.
    Text in Illustration 
    *1
    Slip Ring
    *2
    Rotor
    *3
    Ohmmeter

    1. Using an ohmmeter, measure the resistance between the slip ring and rotor.

      Standard Resistance:
      Tester Condition
      Specified Condition
      Slip ring - Rotor
      1 MΩ or higher

      If the result is not as specified, replace the generator rotor assembly.



    A124106E07
  1. Using a vernier caliper, measure the slip ring diameter.
    Text in Illustration 
    *a
    Diameter

    Standard diameter:
    14.2 to 14.4 mm (0.560 to 0.566 in.)

    Minimum diameter:
    14.0 mm (0.552 in.)

    If the diameter is less than the minimum, replace the generator rotor assembly.