Home › Power Source / Network · 1AZ-FE BATTERY / CHARGING › GENERATOR

GENERATOR > INSPECTION

for Preparation Click here



1. INSPECT GENERATOR PULLEY WITH CLUTCH


    A130538E03
  1. Hold the center of the generator pulley with clutch, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
    Text in Illustration 
    *a
    Free
    *b
    Lock
    If the result is not as specified, replace the generator pulley with clutch.



2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    A128079E14
  1. Using a vernier caliper, measure the length of the exposed brushes.
    Text in Illustration 
    *a
    Length

    Standard exposed length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    If the exposed length is less than the minimum, replace the generator brush holder assembly.



3. INSPECT GENERATOR ROTOR ASSEMBLY


    A079306E02
  1. Check that the generator rotor bearing is not rough or worn.
    If necessary, replace the generator rotor assembly.



  1. Check the generator rotor assembly for an open circuit.



      B012264E23
    1. Using an ohmmeter, measure the resistance between the slip rings.
      Text in Illustration 
      *1
      Ohmmeter
      *2
      Slip Ring

      Standard Resistance:
      Tester Connection
      Specified Condition
      Slip ring
      2.3 to 2.7 Ω

      If the result is not as specified, replace the generator rotor assembly.



  1. Check the generator rotor assembly for a short to ground.



      B012265E18
    1. Using an ohmmeter, measure the resistance between the slip ring and rotor.
      Text in Illustration 
      *1
      Ohmmeter
      *2
      Rotor
      *3
      Slip Ring

      Standard Resistance:
      Tester Connection
      Specified Condition
      Slip ring - Rotor
      10 MΩ or higher

      If the result is not as specified, replace the generator rotor assembly.



    A124106E07
  1. Using a vernier caliper, measure the slip ring diameter.
    Text in Illustration 
    *a
    Diameter

    Standard diameter:
    14.2 to 14.8 mm (0.559 to 0.583 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    If the diameter is less than the minimum, replace the generator rotor assembly.



4. INSPECT GENERATOR DRIVE END FRAME BEARING


    A128616
  1. Check that the generator drive end frame bearing is not rough or worn.

    OK:
    The generator drive end frame bearing rotates smoothly.

    If the generator drive end frame bearing does not rotate smoothly, replace the generator drive end frame bearing.