Home › Power Source / Network ยท 1AZ-FE BATTERY / CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR REAR END COVER


    A128610
  1. Remove the 3 nuts and generator rear end cover.



2. REMOVE GENERATOR TERMINAL INSULATOR


    A128609
  1. Remove the generator terminal insulator from the generator coil assembly.



3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A128611
  1. Remove the 2 screws and generator brush holder assembly from the generator coil assembly.



4. REMOVE GENERATOR COIL ASSEMBLY


    A128612
  1. Remove the 4 bolts.



    A128613
  1. Remove the bolt and cord clip.



    A128614E03
  1. Using SST, remove the generator coil assembly.
    Text in Illustration 
    *1
    Hold
    *2
    Turn

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)



    A118365E01
  1. Remove the generator washer.



5. REMOVE GENERATOR PULLEY WITH CLUTCH


    A215198
  1. Using a screwdriver, puncture the center of the generator pulley cap and pry it off.

    NOTICE:
    Do not reuse the generator pulley cap.

  1. Hold the generator drive end frame assembly in a vise between aluminum plates.



    A128069E03
  1. Confirm SST (A) and (B) shown in the illustration.
    Text in Illustration 
    *1
    SST (A)
    *2
    SST (B)

    SST
    09820-63021  



    A193955E02
  1. Place the rotor shaft end into SST (A).
    Text in Illustration 
    *1
    Rotor Shaft
    *2
    SST (A)



    A193956E02
  1. Fit SST (B) to the generator pulley with clutch.
    Text in Illustration 
    *1
    Generator Pulley with Clutch
    *2
    SST (A)
    *3
    SST (B)



    A193958E02
  1. Loosen the generator pulley with clutch by turning SST (B) in the direction shown in the illustration.
    Text in Illustration 
    *1
    SST (A)
    *2
    SST (B)

    NOTICE:
    1. Check that the generator drive end frame assembly is secured in the vise tightly.
    2. Hold SST (A) tightly during the operation.

  1. Remove SST from the generator assembly.

  1. Remove the generator pulley with clutch from the rotor shaft.



6. REMOVE GENERATOR ROTOR ASSEMBLY


    A220963
  1. Remove the generator rotor assembly.



7. REMOVE GENERATOR DRIVE END FRAME BEARING


    A128617
  1. Remove the 4 screws and bearing retainer plate from the generator drive end frame assembly.



    A128618E03
  1. Using SST and a hammer, tap out the generator drive end frame bearing from the generator drive end frame assembly.
    Text in Illustration 
    *1
    Generator Drive End Frame Bearing

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)