GENERATOR > REASSEMBLY |
| 1. INSTALL GENERATOR DRIVE END FRAME BEARING |
![]() |
Using SST and a press, press in a new generator drive end frame bearing.
![]() |
Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate.
| *a | Tab |
| *b | Cutout |
Install the 4 screws.
| 2. INSTALL GENERATOR ROTOR ASSEMBLY |
Place the drive end frame on the generator pulley with clutch.
![]() |
Install the generator rotor assembly to the drive end frame.
| 3. INSTALL GENERATOR CLUTCH PULLEY |
Temporarily install the generator pulley with clutch onto the rotor shaft.
Mount the generator drive end frame in a vise tightly.
![]() |
Confirm SST (A) and (B) shown in the illustration.
| *1 | SST (A) |
| *2 | SST (B) |
![]() |
Place the rotor shaft end into SST (A).
| *1 | Rotor Shaft |
| *2 | SST (A) |
![]() |
Fit SST (B) to the generator pulley with clutch.
| *1 | Clutch Pulley |
| *2 | SST (B) |
| *3 | SST (A) |
![]() |
Tighten the pulley by turning SST (B) in the direction shown in the illustration.
| *1 | SST (B) |
| *2 | SST (A) |
| *a | Fulcrum Length 100 mm (3.94 in.) |
| *b | Fulcrum Length 255 mm (10.04 in.) |
Remove SST from the generator assembly.
Check that the generator pulley with clutch rotates smoothly.
Install a new generator pulley cap to the generator pulley with clutch.
| 4. INSTALL GENERATOR COIL ASSEMBLY |
![]() |
Place a new generator washer on the generator rotor.
![]() |
Using a deep socket wrench (21 mm) and a press, slowly press in the generator coil assembly.
| *1 | Deep Socket Wrench (21 mm) |
![]() |
Install the 4 bolts.
| 5. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
While pushing the 2 brushes into the generator brush holder assembly, insert a 1.0 mm (0.0394 in.) pin into the brush holder hole.
| *1 | Pin |
![]() |
Install the brush holder assembly to the generator coil with the 2 screws.
Pull out the pin from the generator brush holder.
| *1 | Pin |
| 6. INSTALL GENERATOR TERMINAL INSULATOR |
![]() |
Install the generator terminal insulator to the generator coil.
| 7. INSTALL GENERATOR REAR END COVER |
![]() |
Install the generator rear end cover to the generator coil with the 3 nuts.