Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE

WASHER NOZZLE > ADJUSTMENT

for Preparation Click here



1. REMOVE WASHER NOZZLE SUB-ASSEMBLY


    E226459E01
  1. Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Be careful not to damage the windshield.

    HINT:
    Tape the screwdriver tip before use.



    E226460
  1. Remove the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.

    HINT:
    Use the same procedure for the RH side and LH side.



2. ADJUST WASHER NOZZLE SUB-ASSEMBLY


  1. Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.


    E226092E03


    Text in Illustration 
    *a
    Washer Fluid Spray Angle
    *b
    Part Number



3. INSTALL WASHER NOZZLE SUB-ASSEMBLY
  1. Connect a new washer nozzle sub-assembly to the washer hose.



    E226461E01
  1. Engage the 2 claws to install the washer nozzle sub-assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.