Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER ACTUATOR

HEADLIGHT CLEANER ACTUATOR > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY


  1. Engage the guide to the front bumper assembly, then push the tab (A) and engage the claw as shown in the illustration.


    E227513E01

  1. Install the bolt.

    Torque:
    1.1 N*m{ 11 kgf*cm , 10 in.*lbf }

  1. Connect the headlight cleaner hose and engage the clip.

    HINT:
    Use the same procedure for the RH side and LH side.



2. INSTALL HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY


    E227515
  1. Engage the 2 claws to install the headlight washer nozzle sub-assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



3. INSTALL FRONT BUMPER ASSEMBLY
(Click here)