Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR

RAIN SENSOR > REMOVAL

for Preparation Click here



1. REMOVE RAIN SENSOR COVER


    E227520
  1. Disengage the 2 claws and remove the rain sensor cover as shown in the illustration.



2. REMOVE RAIN SENSOR


    E227521
  1. Disconnect the connector.



    E228041E01
  1. Release the stopper by pulling the stopper down and disconnect the rain sensor as shown in the illustration.
    Text in Illustration 
    *1
    Stopper



3. CLEAN WINDSHIELD GLASS

HINT:
  1. Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.
  2. Check that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue before installing the rain sensor.