Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT LEVEL WARNING SWITCH ASSEMBLY

HINT:
The following check should be performed with the windshield washer motor and pump installed to the washer jar.

  1. Fill the washer jar with washer fluid.



    E158668E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A80-1 (S) - A80-2 (E)
    Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or higher
    *
    10 kΩ or higher
    Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or lower
    *
    Below 1 Ω

    HINT:
    *: The level warning switch assembly begins operating when the fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) depending on the vehicle condition.

    Text in Illustration 
    *a
    Component without harness connected
    (Level Warning Switch Assembly)
    If the result is not as specified, replace the level warning switch assembly.