Home › Audio / Visual / Telematics › AUDIO / VIDEO › INSTRUMENT PANEL SPEAKER

INSTRUMENT PANEL SPEAKER > REMOVAL

for Preparation Click here



1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B284921
  1. Disconnect the front door opening trim weatherstrip LH.



2. REMOVE FRONT PILLAR GARNISH


    B278985E01
  1. Pull the upper part of the garnish toward the inside of the cabin and disengage the garnish from the base of the 2 clips.
    Text in Illustration 
    *1
    Front Pillar Garnish Clip

    HINT:
    Make the front pillar garnish LH hang down from the front pillar garnish clip.



    B278986E01
  1. While pushing the tabs on the front pillar garnish clip in the direction indicated by the arrow (A) shown in the illustration, disengage the front pillar garnish clip.

  1. Pull the garnish in the direction indicated by the arrow (B) shown in the illustration to disengage the 2 guides and remove the front pillar garnish LH.



    B278988E01
  1. Protect the curtain shield airbag assembly.
    Text in Illustration 
    *1
    Adhesive Tape
    *2
    Protective Cover
    *3
    Curtain Shield Airbag Assembly

    1. Cover the airbag with a piece of cloth or nylon and secure the edges of the cover with tape as shown in the illustration.

      NOTICE:
      Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.



3. REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    B280301E01
  1. Apply protective tape to the areas shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B280302
  1. Using a moulding remover, disengage the 2 clips and 3 claws.

  1. Disengage the 2 guides to remove the No.1 instrument panel speaker panel sub-assembly.



4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    E231530
  1. Remove the 2 screws.



    E226777
  1. Lift the front No. 2 speaker assembly and disconnect the connector to remove the speaker.

    NOTICE:
    Do not touch the speaker cone.



5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 10 Speakers)


    B281758
  1. Using a moulding remover, pry up on the center instrument cluster finish panel sub-assembly until there is enough of a gap to make it possible to pull on the panel by hand.



    B281757
  1. Pull the center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 7 clips and 2 guides to remove the center instrument cluster finish panel sub-assembly as shown in the illustration.



6. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for 10 Speakers)


    B281759
  1. Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 4 clips as shown in the illustration.

  1. Disconnect the connector to remove the No. 2 instrument panel register assembly.



7. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY (for 10 Speakers)


    B281761
  1. Disengage the 6 clips as shown in the illustration.

  1. Disconnect the connector to remove the No. 1 speaker opening cover assembly.



8. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)


    E223721
  1. Remove the 2 screws.



    E223722
  1. Lift the front No. 3 speaker assembly and disconnect the connector to remove the speaker.

    NOTICE:
    Do not touch the speaker cone.