Home › Engine / Hybrid System ยท 1AZ-FE › STARTING › IGNITION SWITCH

IGNITION SWITCH > REMOVAL

for Preparation Click here



1. REMOVE STEERING COLUMN ASSEMBLY
(Click here).


2. REMOVE STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY
  1. Using a center punch, mark the center of the 2 tapered-head bolts.

  1. Using a 3 to 4 mm (0.118 to 0.157 in.) diameter drill bit, drill a hole in each tapered-head bolt.



    C239333
  1. Using a screw extractor, remove each tapered-head bolt, and then remove the steering column upper with switch bracket assembly from the steering column assembly.



3. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY


    A255481
  1. Disengage the 2 claws and remove the ignition or starter switch assembly.