Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
(Click here)


2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    E226470E02
  1. Disconnect each connector.

  1. Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

    NOTICE:
    If the claw is pulled with excessive force, it may break.



3. REMOVE TILT AND TELESCOPIC SWITCH (for Power Tilt and Power Telescopic Steering Column)


    C239715
  1. Disconnect the connector.

  1. Disengage the claw and pull out the tilt and telescopic switch.

    NOTICE:
    Pushing on the claw too hard will break the claw.



4. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    E227542
  1. Disconnect the connector.

  1. Using a screwdriver, disengage the 3 claws and remove the headlight dimmer switch assembly.