Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A255403
  1. Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.



2. REMOVE IGNITION COIL ASSEMBLY
  1. Disconnect the 4 ignition coil assembly connectors.



    A207955
  1. Remove the 4 bolts and 4 ignition coil assemblies.



3. REMOVE SPARK PLUG


    A207956
  1. Using a spark plug wrench, remove the 4 spark plugs.