Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH

ENGINE HOOD COURTESY SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) (for LHD)


    B281674
  1. Apply MP grease to the sliding areas of the lock.

  1. Connect the hood lock control cable assembly.

  1. Install the hood lock assembly with the 2 bolts and hood lock bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    HINT:
    The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.

  1. Connect the connector.



2. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) (for RHD)


    B281675
  1. Apply MP grease to the sliding areas of the lock.

  1. Connect the hood lock control cable assembly.

  1. Install the hood lock assembly with the 2 bolts and hood lock bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    HINT:
    The hood lock nut cap is a non-reusable part. Be sure to install it after performing the Inspect Hood Sub-assembly and Adjust Hood Sub-assembly steps.

  1. Connect the connector.



3. INSTALL FRONT BUMPER ASSEMBLY
(Click here)


4. INSPECT HOOD SUB-ASSEMBLY


  1. Check that the clearance measurements of areas *a through *f are within each standard range.


    B281655E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    *a
    5.5 to 9.5 mm (0.217 to 0.374 in.)
    *b
    -0.8 to 3.2 mm (-0.0315 to 0.126 in.)
    *c
    8.7 to 12.7 mm (0.345 to 0.50 in.)
    *d
    2.8 to 6.8 mm (0.110 to 0.268 in.)
    *e
    2.3 to 5.3 mm (0.0906 to 0.209 in.)
    *f
    -1.5 to 1.5 mm (-0.0590 to 0.0590 in.)



5. ADJUST HOOD SUB-ASSEMBLY
(Click here)