OIL AND OIL FILTER > REPLACEMENT |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and drain the oil into a container.
Clean and install the oil pan drain plug with a new gasket.
| 2. REMOVE OIL FILTER SUB-ASSEMBLY |
Using SST, remove the oil filter sub-assembly.
| 3. INSTALL OIL FILTER SUB-ASSEMBLY |
Check and clean the oil filter sub-assembly installation surface.
Apply clean engine oil to the gasket of a new oil filter sub-assembly.
Lightly screw the oil filter sub-assembly into place by hand. Tighten it until the gasket contacts the seat.
Using SST, tighten the oil filter sub-assembly.
Depending on the work space available, choose from the following:
| 4. ADD ENGINE OIL |
Add new engine oil.
| Oil Grade | Oil Viscosity (SAE) |
| API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil |
|
| API grade SL, SM or SN multigrade engine oil |
|
| Item | Standard Condition |
| Drain and refill with oil filter change | 4.3 liters (4.5 US qts., 3.8 Imp. qts.) |
| Drain and refill without oil filter change | 4.1 liters (4.3 US qts., 3.6 Imp. qts.) |
| Dry fill | 5.0 liters (5.3 US qts., 4.4 Imp. qts.) |
Install the oil filler cap.
| 5. INSPECT FOR OIL LEAK |
Start the engine. Make sure that there are no oil leaks from the area that was worked on.