OIL PUMP > INSPECTION |
| 1. INSPECT OIL JET |
![]() |
Check the oil jet for damage or clogging.
If necessary, repair the cylinder block.
| 2. INSPECT OIL PUMP RELIEF VALVE |
![]() |
Check the oil pump relief valve.
Coat the oil pump relief valve with engine oil, and then check that the oil pump relief valve falls smoothly into the valve hole by its own weight.
If it does not, replace the oil pump relief valve.
If necessary, replace the oil pump assembly.
| 3. INSPECT OIL PUMP ROTOR |
Check the side clearance.
![]() |
Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge.
![]() |
Check the tip clearance.
| *1 | Feeler Gauge |
Using a feeler gauge, measure the clearance between the drive and driven rotor tips.
![]() |
Check the body clearance.
Using a feeler gauge, measure the clearance between the driven rotor and pump body.
| 4. INSPECT NO. 2 CHAIN SUB-ASSEMBLY |
![]() |
Pull the chain with a force of 140 N (14 kgf, 31.5 lbf) as shown in the illustration.
| *a | Measurement Area |
Using a vernier caliper, measure the length of 15 links.
| 5. INSPECT CHAIN TENSIONER PLATE |
![]() |
Using a vernier caliper, measure the chain tensioner plate wear.