Home › Engine / Hybrid System ยท 2GR-FE › EMISSION CONTROL › EMISSION CONTROL SYSTEM

EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FUEL CUT RPM
  1. Start and warm up the engine.

  1. Increase the engine speed to approximately 3000 rpm.



    A192826E04
  1. Use a sound scope to check for injector operating sounds.
    Text in Illustration 
    *1
    Sound Scope

  1. When the accelerator pedal is released, check that injector operating sounds stop momentarily and then resume.

    Standard:
    Item
    Specified Condition
    Fuel cut off rpm
    2500 rpm or higher
    Fuel injection restart rpm
    1400 rpm

    If the result is not as specified, check the injectors, wiring and ECM.



2. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS
  1. Inspect the hoses and gaskets for scratches, cracks or air/oil leaks from the connecting parts.

    HINT:
    If the hoses or gaskets are damaged or some of the connections are loose, they may cause an engine stall or malfunction.



3. INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM
  1. Connect the intelligent tester to the DLC3.



    A255849
  1. Disconnect the fuel vapor feed hose from the purge VSV.

  1. Start the engine.

  1. Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for Evap Control.

  1. Check that vacuum occurs at the purge VSV port.

  1. If vacuum does not occur, check the following items:

    1. Purge VSV (for canister purge)
    2. Clogs in the fuel vapor feed hose connecting the intake air surge tank and purge VSV
    3. Voltage from the ECM PRG terminal (Click here)

  1. Exit Active Test mode and reconnect the fuel vapor feed hose.

  1. Enter the following menus: Powertrain / Engine / Data List / EVAP Purge VSV.

  1. Warm up the engine and drive the vehicle.

  1. Confirm that the purge VSV opens.
    If the result is not as specified, replace the purge VSV, wire harness or ECM.