Home › Engine / Hybrid System ยท 2GR-FE › EMISSION CONTROL › PCV VALVE

PCV VALVE > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A255420
  1. Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

    NOTICE:
    Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.



2. REMOVE VENTILATION VALVE SUB-ASSEMBLY


    A254369
  1. Disconnect the ventilation hose from the ventilation valve sub-assembly.



    A192573
  1. Using a 19 mm deep socket wrench, remove the ventilation valve sub-assembly.