Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR


    A264430E01
  1. Using SST, install the air fuel ratio sensor to the exhaust manifold converter sub-assembly.
    Text in Illustration 
    *a
    Fulcrum Length
    30 mm
    *b
    Fulcrum Length
    300 mm

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 448 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.8 in.) (Click here).
    2. The "with SST" torque value is effective when SST is parallel to the torque wrench.

  1. Connect the air fuel ratio sensor connector.

  1. Install the hose clamp.



2. INSPECT FOR EXHAUST GAS LEAK


3. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
  1. Install the No. 1 exhaust manifold heat insulator with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }