Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Entry and Start System)

DTC    B2793    Transponder Chip Malfunction

DTC    B2794    Unmatched Encryption Code

DTC    B2795    Unmatched Key Code

DTC    B2796    No Communication in Immobiliser System

DTC    B2797    Communication Malfunction No. 1

DTC    B2798    Communication Malfunction No. 2

for Preparation Click here


DESCRIPTION

  1. DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.
  2. DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.
  3. DTC B2795 is stored when a key with a key code that is not registered in the ECU is inserted into the ignition key cylinder.
  4. DTC B2796 is stored when a key is inserted into the ignition key cylinder but no communication occurs between the key and transponder key ECU assembly.
  5. DTC B2797 is stored when a key with a BCC malfunction is inserted into the ignition key cylinder.
  6. DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.

DTC Code
DTC Detection Condition
Trouble Area
B2793
A transponder chip malfunction.
Key
B2794
A key with an incomplete key code is inserted into the ignition key cylinder.
B2795
A key with an unregistered key code is inserted into the ignition key cylinder.
B2796
The key code cannot be transmitted.
B2797
A key with a BCC malfunction is inserted into the ignition key cylinder.
B2798
Key code identification cannot be completed within the specified time.

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly or key is replaced, refer to Service Bulletin.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK DTC OUTPUT
  1. Check for DTCs using all registered keys (Click here).

    HINT:
    If a DTC is stored, check for DTCs with the next key after clearing the DTCs.

    OK:
    DTC B2793, B2974, B2795, B2796, B2797 and B2798 is not output.

    Result:
    Result
    Proceed to
    OK
    A
    NG (all keys)
    B
    NG (any key)
    C



B
REPLACE TRANSPONDER KEY ECU ASSEMBLY

C
REPLACE KEY THAT STORED DTC
A

USE SIMULATION METHOD TO CHECK (Click here)