Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    C222564E01
  1. Using SST, install a new oil seal to the pump.

    SST
    09350-32014   (09351-32140)

    HINT:
    The seal end should be flush with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with ATF.



2. INSTALL FRONT OIL PUMP BODY O-RING


    C055817E03
  1. Coat a new O-ring with ATF, and install it to the oil pump body.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    D009206E23
  1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing upward.
    Text in Illustration 
    *a
    Mark



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    D009206E24
  1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing upward.
    Text in Illustration 
    *a
    Mark



5. INSTALL STATOR SHAFT ASSEMBLY


    D003651E01
  1. Set the stator shaft by aligning each bolt hole.

  1. Using a T30 ''TORX'' socket, install the 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



6. INSTALL CLUTCH DRUM OIL SEAL RING


    D003655E01
  1. Install the 2 clutch drum oil seal rings.

    NOTICE:
    Do not expand the ring ends excessively.



7. INSPECT OIL PUMP ASSEMBLY


    D009205E01
  1. Turn the drive gear using 2 screwdrivers and make sure that it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.