DIFFERENTIAL CASE > DISASSEMBLY |
| 1. REMOVE FRONT DIFFERENTIAL RING GEAR |
![]() |
Place matchmarks on the ring gear and differential case.
| *a | Matchmark |
![]() |
Remove the 10 bolts.
![]() |
Using a plastic-faced hammer, tap on the ring gear to remove it from the case.
| 2. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH |
![]() |
Using a dial indicator, measure the backlash of the side gear.
| Thickness | Thickness |
| 1.0 mm (0.0394 in.) | 1.2 mm (0.0472 in.) |
| 1.1 mm (0.0433 in.) | 1.3 mm (0.0512 in.) |
| 3. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case front tapered roller bearing from the differential case.
![]() |
Using SST, remove the front differential case tapered roller bearing front outer race from the transaxle housing.
| 4. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case rear tapered roller bearing from the differential case.
![]() |
Using SST, remove the front differential case tapered roller bearing rear outer race and shim from the transaxle case.
| 5. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a punch and hammer, loosen the staked part of the differential case.
![]() |
Using a pin punch (5 mm), tap out the pin from the ring gear side.
| 6. REMOVE NO. 1 FRONT DIFFERENTIAL PINION SHAFT |
![]() |
Remove the No. 1 front differential pinion shaft from the differential case.
| 7. REMOVE FRONT DIFFERENTIAL PINION THRUST WASHER |
![]() |
Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front differential side gears and 2 front differential side gear thrust washers from the differential case.
| 8. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL |
![]() |
Using SST, remove the differential side bearing retainer oil seal.
| 9. REMOVE TRANSAXLE HOUSING OIL SEAL |
![]() |
Using SST, remove the transaxle housing oil seal.