WIPER AND WASHER SYSTEM > Wiper ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the I72 windshield wiper relay assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I72-2 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| I72-16 (WIG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I72-12 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Windshield Wiper Relay Assembly) |
|
| ||||
| OK | ||
| ||