Home › Engine / Hybrid System · 1AZ-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSPECTION

for Preparation Click here



1. INSPECT HEATED OXYGEN SENSOR


    A196092E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E21-1 (HT1B) - E21-2 (+B)
    20°C (68°F)
    9 to 14 Ω
    E21-1 (HT1B) - E21-4 (E2)
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Heated Oxygen Sensor)
    If the result is not as specified, replace the heated oxygen sensor.