AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the radio and display receiver assembly connector.
Disconnect the No. 1 stereo jack adapter assembly connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I155-25 (ADPG) - I146-9 (AUXO) | Always | Below 1 Ω |
| I155-11 (AGND) - I146-10 (AGND) | Always | Below 1 Ω |
| I155-26 (VAR+) - I146-6 (ARO) | Always | Below 1 Ω |
| I155-28 (VAL+) - I146-7 (ALO) | Always | Below 1 Ω |
| I155-27 (VA-) - I146-8 (ASGN) | Always | Below 1 Ω |
| I155-25 (ADPG) - Body ground | Always | 10 kΩ or higher |
| I155-11 (AGND) - Body ground | Always | 10 kΩ or higher |
| I155-26 (VAR+) - Body ground | Always | 10 kΩ or higher |
| I155-28 (VAL+) - Body ground | Always | 10 kΩ or higher |
| I155-27 (VA-) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||