Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the data signal from a USB device to the navigation ECU sub-assembly via this circuit.

WIRING DIAGRAM


E229860E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    E226480E04
  1. Disconnect the navigation ECU sub-assembly connector.

  1. Disconnect the No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I147-2 (US1-) - I146-2 (UDO-)
    Always
    Below 1 Ω
    I147-3 (US1+) - I146-3 (UDO+)
    Always
    Below 1 Ω
    I147-5 (USG1) - I146-5 (UJSS)
    Always
    Below 1 Ω
    I147-2 (US1-) - Body ground
    Always
    10 kΩ or higher
    I147-3 (US1+) - Body ground
    Always
    10 kΩ or higher
    I147-5 (USG1) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation ECU Sub-assembly)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)