NAVIGATION SYSTEM > Navigation Voice Circuit |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the navigation ECU sub-assembly connector.
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| I65-2 (RL+) - I69-15 (II1+) | Always | Below 1 Ω |
| I65-6 (RL-) - I69-14 (II1-) | Always | Below 1 Ω |
| I69-18 (SLD1) - Body ground | Always | 10 kΩ or higher |
| I65-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| I65-6 (RL-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||