Home › Engine / Hybrid System ยท 2GR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE REAR OIL SEAL


    A132245E03
  1. Apply MP grease to a new engine rear oil seal lip.
    Text in Illustration 
    *1
    Retainer
    *a
    Oil seal tap in depth
    (-0.5 to 0.5 mm)

  1. Using SST and a hammer, tap in the engine rear oil seal.

    SST
    09223-15030  
    09950-70010   (09951-07150)

    Oil seal tap in depth:
    -0.5 to 0.5 mm (-0.0196 to 0.0196 in.)



2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. Clean the 8 bolts and 8 bolt holes.



    A114342
  1. Install the front drive plate spacer.

    HINT:
    Align the pin of the front drive plate spacer with the pin hole of the crankshaft.



    A192405E03
  1. Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.
    Text in Illustration 
    *1
    Drive Plate
    *2
    Rear Spacer
    V100135
    Transaxle Side



    P000601E12
  1. Apply adhesive to 2 or 3 threads of each bolt.
    Text in Illustration 
    *1
    Adhesive

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    A132243E01
  1. In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

    Torque:
    83 N*m{ 846 kgf*cm , 61 ft.*lbf }

    NOTICE:
    Do not start the engine for at least an hour after installing the drive plate.



3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)