Home › Engine / Hybrid System ยท 2GR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A205853E01
  1. Using SST, hold the crankshaft pulley.

    SST
    09213-70011   (09213-70020)
    09330-00021  



    A132243
  1. Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly and rear drive plate spacer.



3. REMOVE ENGINE REAR OIL SEAL


    A132244E11
  1. Using a knife, cut off the engine rear oil seal lip.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Cut Position

  1. Using a screwdriver, pry out the engine rear oil seal.

    NOTICE:
    Be careful not to damage the crankshaft.

    HINT:
    Tape the screwdriver tip before use.