Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TIMING CHAIN COVER OIL SEAL
  1. Apply MP grease to the lip of a new timing chain cover oil seal.

    NOTICE:
    Do not allow foreign matter to contact the lip of the timing chain cover oil seal.



    A264166E01
  1. Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly edge.

    SST
    09223-22010  

    NOTICE:
    1. Keep the lip of the timing chain cover oil seal free from foreign matter.
    2. Do not tap in the timing chain cover oil seal at an angle.



2. INSTALL CRANKSHAFT PULLEY
  1. Align the pulley set key with the key groove of the crankshaft pulley.



    A264167E01
  1. Using SST, hold the crankshaft pulley and install the pulley bolt.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09213-54015   (91651-60855)
    09330-00021  

    Torque:
    180 N*m{ 1835 kgf*cm , 132 ft.*lbf }



3. INSTALL V-RIBBED BELT


    A127534E01
  1. Set the V-ribbed belt onto each part as shown in the illustration.
    Text in Illustration 
    *1
    V-ribbed Belt Tensioner Assembly
    *2
    Generator
    *3
    Water Pump
    *4
    Cooler Compressor
    *5
    Crankshaft
    *6
    Idler

  1. Using SST, slowly turn the V-ribbed belt tensioner assembly clockwise and install the V-ribbed belt.

    SST
    09216-42010  

    NOTICE:
    1. Make sure that SST and other tools are set to the V-ribbed belt tensioner assembly securely.
    2. When compressing the V-ribbed belt tensioner assembly, slowly turn the V-ribbed belt tensioner assembly.



4. INSTALL FRONT FENDER APRON SEAL RH


5. INSTALL ENGINE UNDER COVER RH


6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH


7. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }