FRONT CRANKSHAFT OIL SEAL > REMOVAL |
| 1. REMOVE FRONT WHEEL RH |
| 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH |
| 3. REMOVE ENGINE UNDER COVER RH |
| 4. REMOVE FRONT FENDER APRON SEAL RH |
| 5. REMOVE V-RIBBED BELT |
![]() |
Release the V-ribbed belt tension by turning the V-ribbed belt tensioner counterclockwise, and remove the V-ribbed belt from the V-ribbed belt tensioner.
While turning the V-ribbed belt tensioner counterclockwise, align its holes, and then insert a 5 mm hexagon wrench into the holes to fix the V-ribbed belt tensioner.
| 6. REMOVE CRANKSHAFT PULLEY |
![]() |
Using SST, loosen the crankshaft pulley bolt.
| *a | Hold |
![]() | Turn |
![]() |
Using SST, remove the crankshaft pulley bolt and crankshaft pulley.
| *a | Hold |
![]() | Turn |
![]() |
Remove the pulley set key from the crankshaft.
| 7. REMOVE TIMING CHAIN CASE OIL SEAL |
![]() |
Using a knife, cut off the timing chain case oil seal lip.
| *1 | Protective Tape |
| *a | Cut Position |
Using a screwdriver, pry out the timing chain case oil seal.