Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


3. REMOVE ENGINE UNDER COVER RH


4. REMOVE FRONT FENDER APRON SEAL RH


5. REMOVE V-RIBBED BELT


    A264360E01
  1. Using SST, slowly turn the V-ribbed belt tensioner assembly clockwise.

    NOTICE:
    1. Make sure that SST and other tools are set to the V-ribbed belt tensioner assembly securely.
    2. When compressing the V-ribbed belt tensioner assembly, slowly turn the V-ribbed belt tensioner assembly.

    SST
    09216-42010  

  1. Remove the V-ribbed belt from each pulley and slowly return the V-ribbed belt tensioner assembly.



6. REMOVE CRANKSHAFT PULLEY


    A264147E01
  1. Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A127536E01
  1. Using SST and the pulley bolt, remove the crankshaft pulley.
    Text in Illustration 
    *1
    Pulley Bolt
    *a
    Hold
    *b
    Turn

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    HINT:
    Apply a lubricant to the threads and end of SST.



7. REMOVE TIMING CHAIN COVER OIL SEAL


    A264164E01
  1. Using a screwdriver, pry out the timing chain cover oil seal.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    1. Tape the screwdriver tip before use.
    2. Do not damage the surface of the timing chain cover oil seal press fit hole or the crankshaft.