Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE VALVE LIFTER


    A062842E01
  1. Remove the 16 valve lifters from the cylinder head.

    HINT:
    Arrange the valve lifters in the correct order.



2. REMOVE INTAKE VALVE


    A128225E06
  1. Using SST and wooden blocks, remove the 16 valve retainer locks.

    SST
    09202-70020   (09202-00010)
    Text in Illustration 
    *1
    Wooden Block

  1. Remove the 8 valve retainers, compression springs and 8 intake valves.

    HINT:
    Arrange the removed parts in the correct order.



3. REMOVE EXHAUST VALVE


    A128226E05
  1. Using SST and wooden blocks, remove the 16 valve retainer locks.

    SST
    09202-70020   (09202-00010)
    Text in Illustration 
    *1
    Wooden Block

  1. Remove the 8 valve retainers, compression springs and 8 exhaust valves.

    HINT:
    Arrange the removed parts in the correct order.



4. REMOVE VALVE STEM OIL SEAL


    A013356E01
  1. Using needle nose pliers, remove the 16 oil seals.



5. REMOVE VALVE SPRING SEAT


    A062845E01
  1. Using compressed air and a Magnet Hand, remove the 16 valve spring seats by blowing air onto them.



6. REMOVE NO. 1 STRAIGHT HEAD SCREW PLUG


    A062841
  1. Using a 14 mm straight hexagon wrench, remove the 2 No. 1 straight head screw plugs and 2 gaskets.

    NOTICE:
    If water leaks from the straight screw plug or the plug is corroded, replace it.



7. REMOVE STUD BOLT


8. REMOVE RING PIN