BRAKE MASTER CYLINDER (for LHD) > REMOVAL |
| 1. DRAIN BRAKE FLUID |
| 2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
| 3. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY |
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
![]() |
Remove the 10 bolts and front outer cowl top panel sub-assembly.
| 4. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 9 clips and cool air intake duct seal.
| 5. REMOVE INLET AIR CLEANER ASSEMBLY (for 2AR-FE) |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (for 2AR-FE) |
![]() |
Disconnect the vacuum switching valve assembly from the air cleaner hose.
![]() |
Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.
![]() |
Separate the fuel vapor feed hose from the air cleaner hose.
![]() |
Disconnect the ventilation hose from the cylinder head cover.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
![]() |
Release the 2 clamps and remove the air cleaner cap sub-assembly.
| 7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (for 2AR-FE) |
| 8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2AR-FE) |
![]() |
Disconnect the wire harness clamp.
Remove the 2 bolts and air cleaner case sub-assembly.
| 9. REMOVE INLET NO. 2 AIR CLEANER (for 2GR-FE) |
![]() |
Disconnect the 2 wire harness clamps and vacuum hose clamp.
Remove the 2 bolts and inlet No. 2 air cleaner.
| 10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (for 2GR-FE) |
![]() |
Disconnect the mass air flow meter connector and wire harness clamp.
![]() |
Disconnect the 3 hoses.
Separate the ventilation hose.
![]() |
Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.
Release the 2 clamps and remove the air cleaner cap with hose.
| 11. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (for 2GR-FE) |
| 12. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2GR-FE) |
![]() |
Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.
Remove the 2 bolts and air cleaner case sub-assembly.
| 13. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() |
Disconnect the reservoir level switch connector and disengage the clamp.
![]() |
Using a union nut wrench, disconnect the 6 brake lines and remove the brake master cylinder to way tube from the brake master cylinder sub-assembly.
![]() |
Remove the 2 nuts, front No. 1 brake tube way and brake master cylinder sub-assembly from the brake booster assembly.
| *1 | Master Cylinder Piston |
| 14. REMOVE BRAKE MASTER CYLINDER O-RING |
Remove the brake master cylinder O-ring from the brake master cylinder sub-assembly.