DTC B1422/22 Compressor Lock Sensor Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1422/22 | Open or short in A/C lock sensor circuit |
|

| 1.INSPECT COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR) |
![]() |
Disconnect the E73 cooler compressor assembly (A/C lock sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E73-1 (SSR+) - E73-2 (SSR-) | 20°C (68°F) | 160 to 320 Ω |
| *a | Component without harness connected (Cooler Compressor Assembly (A/C Lock Sensor)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - COOLER COMPRESSOR ASSEMBLY (A/C LOCK SENSOR)) |
Disconnect the I77 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I77-8 (LOCK) - E73-1 (SSR+) | Always | Below 1 Ω |
| I77-13 (SG-2) - E73-2 (SSR-) | Always | Below 1 Ω |
| I77-8 (LOCK) - Body ground | Always | 10 kΩ or higher |
| I77-13 (SG-2) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC) | C |
|
| ||||
|
| ||||
| A | ||
| ||