Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > TERMINALS OF ECU

for Preparation Click here



AIR CONDITIONING AMPLIFIER ASSEMBLY

E226604E05

HINT:
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.


Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
I77-1 (IG+) - I77-14 (GND)
B - W-B
Power source (IG)
Ignition switch ON
11 to 14 V
I77-1 (IG+) - I77-14 (GND)
B - W-B
Power source (IG)
Ignition switch off
Below 1 V
I77-2 (SOL+) - I77-14 (GND)
W - W-B*3
GR - W-B*4
Compressor solenoid operation signal
Engine running
A/C switch: on
Blower switch: LO
Pulse generation
(See waveform 1)
I77-5 (TAM) - I77-13 (SG-2)
P - GR
Ambient temperature sensor signal
Ignition switch ON
Ambient temperature: 25°C (77°F)
1.35 to 1.75 V
I77-5 (TAM) - I77-13 (SG-2)
P - GR
Ambient temperature sensor signal
Ignition switch ON
Ambient temperature: 40°C (104°F)
0.9 to 1.2 V
I77-7 (FLOQ) - I77-13 (SG-2)
G - GR*3
LG - GR*4
A/C flow sensor signal
Ignition switch ON
A/C switch: off
3.8 to 4.2 V
I77-7 (FLOQ) - I77-13 (SG-2)
G - GR*3
LG - GR*4
A/C flow sensor signal
Ignition switch ON
A/C switch: on
Blower switch: HI
0.7 to 3.8 V
I77-8 (LOCK) - I77-14 (GND)*1
SB - W-B
A/C lock sensor signal
Engine running
Blower switch: LO
A/C switch: on
Pulse generation
(See waveform 2)
I77-9 (PRE) - I77-13 (SG-2)
R - GR
Air conditioning pressure sensor signal
Engine running
A/C system operating
Refrigerant pressure: Abnormal pressure (more than 3025 kPa (30.9 kgf/cm2, 439 psi))
4.80 V or higher
I77-9 (PRE) - I77-13 (SG-2)
R - GR
Air conditioning pressure sensor signal
Engine running
A/C system operating
Refrigerant pressure: Abnormal pressure (less than 176 kPa (1.8 kgf/cm2, 25 psi))
Below 0.50 V
I77-9 (PRE) - I77-13 (SG-2)
R - GR
Air conditioning pressure sensor signal
Engine running
A/C system operating
Refrigerant pressure: Normal pressure (less than 3025 kPa (30.9 kgf/cm2, 439 psi) and more than 176 kPa (1.8 kgf/cm2, 25 psi))
0.50 to 4.80 V
I77-10 (S5-3) - I77-13 (SG-2)
V - GR
Power supply for air conditioning pressure sensor
Ignition switch ON
A/C switch: on
4.75 to 5.25 V
I77-10 (S5-3) - I77-13 (SG-2)
V - GR
Power supply for air conditioning pressure sensor
Ignition switch ON
A/C switch: off
Below 1 V
I77-11 (CANH) - I77-12 (CANL)
V - W
CAN communication system
CAN communication occurring
Pulse generation
I77-13 (SG-2) - Body ground
GR - Body ground
Ground for air conditioning pressure sensor, ambient temperature sensor, A/C lock sensor
Always
Below 1 V
I77-14 (GND) - Body ground
W-B - Body ground
Ground for main power supply
Always
Below 1 V
I77-20 (MGC) - I77-14 (GND)*1
B - W-B
Magnetic clutch operation signal
Engine running
Blower switch: LO
A/C switch: off
11 to 14 V
I77-20 (MGC) - I77-14 (GND)*1
B - W-B
Magnetic clutch operation signal
Engine running
Blower switch: LO
A/C switch: on
Below 1 V
I77-21 (B) - I77-14 (GND)
Y - W-B
Power source (Back-up)
Always
11 to 14 V
I77-22 (BLW) - I77-14 (GND)
R - W-B
Blower motor speed control signal
Ignition switch ON
Blower switch: LO
Pulse generation
(See waveform 3)
I77-26 (NAIN) - I77-14 (GND)*2
Y - W-B
Ion generator assembly operation condition signal
Ignition switch ON
Blower switch: LO
Below 1 V
I77-26 (NAIN) - I77-14 (GND)*2
Y - W-B
Ion generator assembly operation condition signal
Ignition switch ON
Blower switch: OFF
4.5 to 5.5 V
I77-29 (TR) - I77-34 (SG-1)
P - LG
Room temperature sensor signal
Ignition switch ON
Cabin temperature: 25°C (77°F)
1.8 to 2.2 V
I77-29 (TR) - I77-34 (SG-1)
P - LG
Room temperature sensor signal
Ignition switch ON
Cabin temperature: 40°C (104°F)
1.2 to 1.6 V
I77-30 (S5-1) - I77-14 (GND)
B - W-B
Power supply for A/C flow sensor
Ignition switch off
Below 1 V
I77-30 (S5-1) - I77-14 (GND)
B - W-B
Power supply for A/C flow sensor
Ignition switch ON
4.5 to 5.5 V
I77-32 (TSP) - I77-14 (GND)
Y - W-B*3
R - W-B*4
Solar sensor signal (for Front passenger side)
Ignition switch ON
Solar sensor subjected to electric light
0.8 to 4.3 V
I77-32 (TSP) - I77-14 (GND)
Y - W-B*3
R - W-B*4
Solar sensor signal (for Front passenger side)
Ignition switch ON
Solar sensor covered with a cloth
Below 0.8 V
I77-33 (TSD) - I77-14 (GND)
R - W-B*3
Y - W-B*4
Solar sensor signal (for Driver side)
Ignition switch ON
Solar sensor subjected to electric light
0.8 to 4.3 V
I77-33 (TSD) - I77-14 (GND)
R - W-B*3
Y - W-B*4
Solar sensor signal (for Driver side)
Ignition switch ON
Solar sensor covered with a cloth
Below 0.8 V
I77-34 (SG-1) - Body ground
LG - Body ground
Ground for room temperature sensor
Always
Below 1 V
I77-37 (LIN1) - I77-14 (GND)
V - W-B
LIN communication signal
Ignition switch ON
Pulse generation
I77-39 (NANO) - I77-14 (GND)*2
R - W-B
Ion generator operation signal
Ignition switch ON
Blower switch: LO
11 to 14 V
I77-39 (NANO) - I77-14 (GND)*2
R - W-B
Ion generator operation signal
Ignition switch ON
Blower switch: OFF
Below 1 V
z1-2 (BUS G) - Body ground
-
Ground for BUS IC
Always
Below 1 V
z1-3 (BUS) - z1-2 (BUS G)
-
BUS IC control signal
Ignition switch ON
Pulse generation
z1-4 (B BUS) - z1-2 (BUS G)
-
Power supply for BUS IC
Always
11 to 14 V
z1-5 (SGA) - Body ground
-
Ground for evaporator temperature sensor
Always
Below 1 V
z1-6 (TEA) - z1-5 (SGA)
-
Evaporator temperature sensor signal
Ignition switch ON
Evaporator temperature: 0°C (32°F)
1.7 to 2.1 V
z1-6 (TEA) - z1-5 (SGA)
-
Evaporator temperature sensor signal
Ignition switch ON
Evaporator temperature: 15°C (59°F)
0.9 to 1.3 V
  1. *1: for 2GR-FE
  2. *2: w/ Ion Generator Assembly
  3. *3: for LHD
  4. *4: for RHD


    E106664E02
  1. Waveform 1:
    Item
    Content
    Terminal No.
    I77-2 (SOL+) - I77-14 (GND)
    Tool Setting
    5 V/DIV., 500 μs/DIV.
    Vehicle Condition
    Engine running
    A/C switch: on
    Blower switch: LO



  2. E116941E01
  3. Waveform 2:
    Item
    Content
    Terminal No.
    I77-8 (LOCK) - I77-13 (SG-2)
    Tool Setting
    200 mV/DIV., 10 ms./DIV.
    Vehicle Condition
    Engine running
    Blower switch: LO
    A/C switch: on



  4. E103396E01
  5. Waveform 3:
    Item
    Content
    Terminal No.
    I77-22 (BLW) - I77-14 (GND)
    Tool Setting
    1 V/DIV., 500 μs/DIV.
    Vehicle Condition
    Ignition switch ON
    Blower switch: LO


AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD)

E182384E04

HINT:
Check from the rear of the connector while it is connected to the air conditioning panel (heater control switch board).


Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
I56-2 (IG+) - I56-6 (GND)
R - W-B
Power source (IG)
Ignition switch off
Below 1 V
I56-2 (IG+) - I56-6 (GND)
R - W-B
Power source (IG)
Ignition switch ON
11 to 14 V
I56-6 (GND) - Body ground
W-B - Body ground
Ground for air conditioning panel (heater control switch board)
Always
Below 1 V
I56-9 (LIN1) - Body ground
V - Body ground
LIN communication signal
Ignition switch ON
Pulse generation
I56-11 (ILL+) - I56-15 (ILL-)
G - W-B
Light control switch signal
Light control switch off
Below 1 V
I56-11 (ILL+) - I56-15 (ILL-)
G - W-B
Light control switch signal
Light control switch tail or head position
11 to 14 V
I56-15 (ILL-) - Body ground
W-B - Body ground
Ground for air conditioning panel (heater control switch board) illumination
Always
Below 1 V

COOLER CONTROL SWITCH ASSEMBLY (for 3 ZONE TYPE)

E228222E01

HINT:
Check from the rear of the connector while it is connected to the cooler control switch assembly.


Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
X1-1 (+B) - X1-16 (GND)
R - W-B
Power source (Back-up)
Always
11 to 14 V
X1-6 (ACC) - X1-16 (GND)
GR - W-B
Power source (ACC)
Ignition switch off
Below 1 V
X1-6 (ACC) - X1-16 (GND)
GR - W-B
Power source (ACC)
Ignition switch ACC
11 to 14 V
X1-7 (IG+) - X1-16 (GND)
V - W-B
Power source (IG)
Ignition switch off
Below 1 V
X1-7 (IG+) - X1-16 (GND)
V - W-B
Power source (IG)
Ignition switch ON
11 to 14 V
X1-8 (ILL+) - X1-16 (GND)
G - W-B
Light control switch signal
Light control switch off
Below 1 V
X1-8 (ILL+) - X1-16 (GND)
G - W-B
Light control switch signal
Light control switch tail or head position
11 to 14 V
X1-10 (RLIN) - Body ground
B - Body ground
LIN communication signal
Ignition switch ON
Pulse generation
X1-16 (GND) - Body ground
W-B - Body ground
Ground for cooler control switch assembly
Always
Below 1 V