DTC P0989 Transmission Fluid Pressure Sensor / Switch "E" Circuit Low |
DTC P0990 Transmission Fluid Pressure Sensor / Switch "E" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0989 | Transmission fluid pressure switch No. 3 is OFF when lock-up occurs in response to a lock-up request (2 trip detection logic). |
|
| P0990 | When both of the following are detected (2 trip detection logic):
|

| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0989 OR P0990) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / DTC.
Read the DTCs using the intelligent tester.
| Display (DTC Output) | Proceed to |
| Only "P0990" is output | A |
| Only "P0989" is output | B |
| "P0989 or P0990" and other DTCs are output | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK TRANSMISSION WIRE (SHORT TO GROUND) |
![]() |
Remove the TCM.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Condition | Specified Condition |
| 19 (TPS3) - Body ground (Valve body assembly) and other terminals | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Wire) |
|
| ||||
| OK | ||
| ||
| 3.CHECK ATF TEMPERATURE SENSOR ASSEMBLY (ATF PRESSURE SWITCH NO. 3) |
Remove the oil strainer assembly.
![]() |
Disconnect the connector from the ATF temperature sensor assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Condition | Specified Condition |
| 1 (TPS3) - Body ground (Valve body assembly) and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK TRANSMISSION WIRE |
Remove the oil strainer assembly.
![]() |
Remove the TCM.
Disconnect the connector from the ATF temperature sensor assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Condition | Specified Condition |
| 19 (TPS3) TCM side - 1 (TPS3) sensor side | Always | Below 1 Ω |
| 1 (TPS3) sensor side - Body ground (Valve body assembly) and other terminals | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Wire) |
| *b | TCM Side |
| *c | ATF Temperature Sensor Side |
|
| ||||
| OK | |
| 5.REPLACE ATF TEMPERATURE SENSOR ASSEMBLY |
| NEXT | |
| 6.CHECK IF DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester on.
Clear the DTCs (Click here).
Perform the monitor drive pattern (Click here).
Enter the following menus: Powertrain / ECT / DTC.
Read the DTCs using the intelligent tester.
| Display (DTC Output) | Proceed to |
| Only "P0989" is output | A |
| No output | B |
|
| ||||
| A | ||
| ||